![]() ![]() ![]() ![]() The board from which I installed the program is quite scratched, but I had no problems with the installation, the program also turns on properly. There was no Internet access when the program was installed, the antivirus was disabled, and so was the firewall. 2.If you have the 2 boards version Delphi/Autocom ,Do not update to 3201 firmware that it wont. 819 subscribers Subscribe 19K views 2 years ago In acest videoclip va este prezentata instalarea/actualizarea driverelor pentru software-ul Delphi versiunea 2016. 2).Copy 3201 firmware files to Program Files > Autocom > Firmware Folder after that to go Autocom Software and click on Upgrade Firmware. On the other hand, the program works and everything is fine. Update firmware steps : 1) Backup older firmware first :go to Program Files > Autocom > Firmware backup. In the device manager, I set the COM10 port, then in the program, when searching, I see COM10 (VCP), but it does not connect and writes: Unknown device. ![]() Now I want to install Autocom / Delphi 2013 on a second laptop, after installing the program and drivers, it does not detect VCI. In the list I found Autocom in the first item, by clicking on it in the right window I chose VCI (Diagnostic Unit) Serial Port later on and the drivers installed nicely on the laptop. Right on Autocom CDP + USB and yellow question mark then -> Update driver software then -> Browse my computer for driver software then -> Let me pick from a list of device drivers on my computer. After connecting the interface to the computer, the drivers do not install themselves, because an error pops up. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |